shape factor

Research of digital clamp-shape power factor table

数字钳形功率因数表的研制

From the above point, further illustrate the reason that the pad design limit stress should be adjusted with its shape factor when the shape factor is lower ( S8).

本文还进一步探明了在形状系数较低时（S8）支座的设计应力应随形状系数进行调整的合理性。

Then theoretical resonance length, small end diameter, displacement node, magnification factor, shape factor and other parameters of the amplitude amplifier pole could be determined.

确定出其理论共振长度、小端直径、位移节点、放大系数、形状因数等参数。

The change of the geotechnical deformation parameters has a great influence on the potential slip curves ( surfaces), and has a little influence on the shape, position and average stability safety factor of the most dangerous potential slip curve ( surface).

岩土的变形参数变化对潜在滑移线（面）的形状影响较大，而对边坡最危险潜在滑移线（面）的形状、位置及平均稳定安全系数影响不大；

The differences of safety factor quantity, slip surface shape and location between stability method based on slip surface FE stress and shear strength reduction method are compared and studied.

比较研究滑面应力分析法与强度折减法在安全系数大小及滑动面形状和位置的差异。

So it can replace data from the teeth shape factor curve and theoretical stress concentration factor curve.

可以替代依靠查齿形系数，应力修正系数线图获得数据的传统方法。

For any section, the ratio Mp / My is called the shape factor.

对于任意的截面, 比值Mp/My叫做形状系数.

The normalized-bandwidth-pulse-shape-factor product, the decaying rate of the tail of time waveform, the opening of the eye diagram, and the envelope uniformity of the second order continuity pulses were addressed, which provides the basic information for the selection of the chip pulse for CDMA systems.

从归一化带宽&脉冲形状因子乘积、时间波形衰减速度、眼图开启度、包络均匀性等角度，详细分析了二阶连续脉冲，为CDMA系统中码片波形的选择提供了基本依据。

Using conduction shape factor to estimate the thermal state of ingots

利用导热形状因子估计钢锭热状态

Two parameters, block spectrum intensity Seq and spectrum shape factor a, which describe the characteristics of the loading block spectrum are defined, and the relationship between the parameters and fatigue crack propagation behaviours is investigated.

定义了疲劳载荷谱的两个特征参数：块谱强度和形状因子，由此去描述载荷谱的特征，并研究了特征参数和疲劳裂纹扩展之间的关系。

The resistance loss on coke bed in CDQ chamber is measured, the influence of inert gas cooling quantity, coke size and shape factor on resistance loss is studied.

测量了干熄炉内焦炭床层的阻力损失，研究了鼓风量、焦炭直径以及形状因子对阻力损失的影响。

Using CSP of Shape Factor to Calculate the Thermodynamical Properties of Fluids

应用形状因子对应态原理计算流体的热力学性质

The prediction of the boundary-layer parameters is in agreement with the experiment before the strong reversing flow by using Williams' shape factor relationship.

在最大反流以前，所预测的附面层位移厚度及形状因子与实验吻合。